Book Online plumber
Burst Pipe
If you see a pool suddenly emerged from nowhere in your backyard or the garden, check your piping system if it is not a case of a burst pipe. Pipe bursting is not a rare phenomenon in households, but it is a cause of worry as water gushing out of the broken pipes can damage the property. But, close the water system, and call our 24 hours emergency number 0400655239. Our plumber gives the best piping repairs and even replaces them if required.
However, first, you have to understand what causes a pipe to burst? Some of these reasons are man created, so you need to be careful, but some happen due to nature. Let us find out these causes.
Corrosion: Main people use DIY drain cleaning products to clean the drains and prevent the same from getting clogged, but sometimes pipe corrosion might happen, which creates week spots that can rupture unexpectedly.
Years of Experience
With extensive high skill
The buildup of the pressure
If the pressure is built up in the pipe due to the clogged drains and toilets for a long time, it will not be able to handle, causing a rupture and a release of water.
Freezing temperatures
In extreme cold weather conditions, water freezes and turns into ice. The ice expands, causing pressure in the inner pipe wall, which can rupture.
What you should do if you see a burst pipe
Before you call a plumber, turn off the main water valve in your home and reduce the damage. Our plumber will find the cause of the damage and will take the necessary action.
Can you prevent the pipe from getting burst?
Many people ask this question from us, and we tell them that to prevent water turns into ice, insert an insulating pipe over the fixed piping system. You can get this insulation pipe from anywhere in the store. The insulation pipe slips over the piping and prevents water from getting frozen. Also, make sure that there are no cracks or openings inside the wall where cold air could get in and freeze the water.
Our advice is that you should be very careful if there is any change in the temperature and find if there are no leaks. You can also take the following precautions:
If the temperature is cold outside, keep the faucets run slowly.
Water flowing through the system can prevent the line from getting frozen.
Remember to keep the cabinet doors open:
If your home kitchen sink is towards an outside wall, keep the cabinet doors open to allow warm air into the cabinet.
Remove the Hose from Faucet
Remove the hose, which farmers fixe in faucet allows the easy flow to drain out of the pipe, there is then little chance for the water getting frozen.
Fix Heat Tape over the pipe:
You can get heat tape from the hardware store. You can fix the same on the pipe to protect it from the cold weather and prevent pipe bursting.
Seal any leakage point:
Make sure to completely seal the leakage point that allows air to pass through space and in the place where there are pipes. Ensure that air leaks are fixed properly around dryer vents and electric wiring.
Keep a check on the room temperature:
Remember to keep the room temperature below 32 degrees in any part of your home where there are water lines. Call the Right Now Plumbing emergency number to deal with any exigency or bursting of any pipe. It is advised not to take the bursting pipe issue lightly as it can lead to grave consequences, but the burst pipes do happen and occur from time to time, so keep the phone number of your plumber always ready.
How to Prevent Water Hammer Damage:
If you hear the pipes banging and clanging when you turn on the water faucet, it is a water hammer. If you continuously hear the sound inside, it is better not to delay but call a professional plumber to deal with this issue. If you avoid this issue, it could be a disaster as whenever the pipes move around, the same can get weaken and eventually breaks.
Water Pressure Issue
Yet another most common problem is that of water pressure. A sudden increase in pressure can cause a pipe to burst in sinks and toilets. To prevent it from happening, keep a regular check of the water pressure using a pressure gauge. Fix it to the tap and turn it on. The meter gauge will give you a reading, and you can take up steps from there. Experts recommend the water pressure to be between 30 and 50 psi. It should not get more than 60 psi.
Prevent Corrosions of pipes
Corrosion happens quite often, especially when there is hard water. Eventually, the pH balance of the water cause corrosion of the pipes as the coating gets worn. It can also cause lead poisoning, which can be harmful. Corrosion and rust can also get built up to pipe getting blocked, narrowed down, and burst. Pipes corrode due to the presence of bacteria known as legionella that is present in water. Though you follow the water chlorination process to deal with this issue, the bacteria keep adding up, so it is better to call an expert to treat the pipes and find the permanent solution.
Finally, ensure that you have your home temperature is not less than 55 Fahrenheit. And to prevent the cost of the repairs, give your property insurance coverage. Many insurance companies offer insurance coverage to the damaging pipes, but it is always better that you keep on checking home pipes.
Our Right Now Plumbing team can handle any piping system, so call at the 24/7 emergency 0400655239 number and ensure peace of mind.